RS400 Brush check

Check the Brush Pattern

Comments
Remove snow and ice from the brush and brush cover before performing any work on the brush.

1. Start the engine
2. Place the Runway Sweeper on a flat surface.
3. Put the sweeper in right standby position
4. Push the joystick forward to put down the brush and drive forward approx. 1 meter to align the support wheels.
5. Let the brush work for approx. 15 seconds to get a clear brush pattern.
   Pull the joystick backwards to raise the brush.
6. Use the template to check the brush pattern. The correct brush pattern should be between 85-125 mm wide and equal on both sides.
7. Pull the joystick to the left to change to left working position.
8. Push the joystick forward to put down the brush and drive forward approx. 1 meter to align the support wheels.
9. Let the brush work for approx. 15 seconds to get a clear brush pattern. Pull the joystick backwards to raise the brush.
10. Use the template to check the brush pattern. The correct brush pattern should be between 85-125 mm wide and equal on both sides.